

The circuit diagram of a 3-bit binary weighted resistor DAC is shown in the following figure − In short, a binary weighted resistor DAC is called as weighted resistor DAC. This section discusses about these two types of DACs in detail − Weighted Resistor DACĪ weighted resistor DAC produces an analog output, which is almost equal to the digital (binary) input by using binary weighted resistors in the inverting adder circuit. In general, the number of binary inputs of a DAC will be a power of two. The block diagram of DAC is shown in the following figure −Ī Digital to Analog Converter (DAC) consists of a number of binary inputs and a single output. This chapter deals with Digital to Analog Converters in detail. The digital signal is represented with a binary code, which is a combination of bits 0 and 1.


Introduction of Variable Length Subnet Mask (VLSM).C Program to find IP Address, Subnet Mask & Default Gateway.Program to determine class, Network and Host ID of an IPv4 address.Internet Protocol version 6 (IPv6) Header.Collision Domain and Broadcast Domain in Computer Network.Difference between Unicast, Broadcast and Multicast in Computer Network.Line Configuration in Computer Networks.Maximum Data Rate (channel capacity) for Noiseless and Noisy channels.Collision Avoidance in wireless networks.
Analog to digital converter application mac#
Analog to digital converter application Pc#
Program to remotely Power On a PC over the internet using the Wake-on-LAN protocol.Sliding Window protocols Summary With Questions.Sliding Window Protocol | Set 3 (Selective Repeat).Sliding Window Protocol | Set 2 (Receiver Side).Sliding Window Protocol | Set 1 (Sender Side).Controlled Access Protocols in Computer Network.Difference between Byte stuffing and Bit stuffing.Multiple Access Protocols in Computer Network.ISRO CS Syllabus for Scientist/Engineer Exam.ISRO CS Original Papers and Official Keys.GATE CS Original Papers and Official Keys.
